top of page

RESET

To reset the trigger after it has been deployed, visually inspect the exterior of the vest, then follow these steps.

IMPORTANT!

If you have any doubts over the integrity of the vest, after a fall for example, take it to your retailer to check that it can be reset, or contact our after-sales service. 

VIDEO TUTORIAL

STEP-BY-STEP

1 > ACCESS THE TRIGGER

To access the trigger, undo the zip on the inside of the front right-hand side of the vest.

Access the trigger

2 > UNSCREW THE CAP

Unscrew the cap
Line up the piston with the slot for the lanyard’s key ball.

Use the Allen key provided wih your C-Protect Air® vest (Allen key 5) to unscrew the cap until the piston is aligned with the slot for the elastic lanyard’s key ball.

3 > INSERT THE KEY BALL

 

Once the piston is lined up, you can insert the key ball into the slot.

Insert the key ball
Screw the cap back on

4 > SCREW THE CAP BACK ON

Holding the key ball in place, screw the cap back on as far as it will go to compress the spring against the piston, held in place by the key ball. Ensure that the piston stays in the correct position while following this procedure.

5 > CHANGE THE PIERCED GAS CANISTER

The trigger mechanism is now reset.

All you have to do now is replace the used, empty gas canister with a new canister.

Unusable CO2 canister with a pierced lid
New CO2 canister with an intact lid, to replace the used canister

 

 

 

 

The new canister is fitted with a sealed lid which the piston will pierce when triggered.

6 > THREAD THE LANYARD

You can now thread the lanyard and its carabiner through the opening provided, from inside to outside, and adjust as necessary.

Now zip up the pocket that contains the trigger system.

Thread the lanyard

Your C-Protect Air® is reset and ready to use.

bottom of page